laser fitting | KitGuru https://www.kitguru.net KitGuru.net - Tech News | Hardware News | Hardware Reviews | IOS | Mobile | Gaming | Graphics Cards Fri, 03 May 2019 16:14:52 +0000 en-US hourly 1 https://wordpress.org/?v=6.4.3 https://www.kitguru.net/wp-content/uploads/2021/06/cropped-KITGURU-Light-Background-SQUARE2-32x32.png laser fitting | KitGuru https://www.kitguru.net 32 32 Alphacool’s new water cooling fittings double as a laser pointer https://www.kitguru.net/components/matthew-wilson/alphacools-new-water-cooling-fittings-double-as-a-laser-pointer/ https://www.kitguru.net/components/matthew-wilson/alphacools-new-water-cooling-fittings-double-as-a-laser-pointer/#respond Fri, 03 May 2019 15:00:04 +0000 https://www.kitguru.net/?p=412388 Building a custom liquid cooling loop is a fulfilling task but it also takes a lot of careful planning and accurate measuring to get it looking as good as can be. Alphacool is hoping to make that last part a bit easier for enthusiasts soon with Eiszapfen laser fittings. The Eiszpafen laser fitting screws into …

The post Alphacool’s new water cooling fittings double as a laser pointer first appeared on KitGuru.]]>
Building a custom liquid cooling loop is a fulfilling task but it also takes a lot of careful planning and accurate measuring to get it looking as good as can be. Alphacool is hoping to make that last part a bit easier for enthusiasts soon with Eiszapfen laser fittings.

The Eiszpafen laser fitting screws into the thread of your radiator or cooling block, then a frickin' laser beam appears to show you exactly where your hard tubing should run, making getting exact measurements an easier task.

These fittings use the standard G 1/4″ thread, so it will be compatible across all custom liquid cooling gear. It also has a 50cm long cable with a 4-pin molex connector to hook it up to a power supply. You can use the included ATX jumper plug to power get it running without a PC.

These are available starting from today directly through Alphacool for €9.95.

KitGuru Says: I built my first custom water cooling loop last year and while I did fine, there were some tubing runs that would have been made much easier with something like this. Are any of you planning to build a custom watercooled PC this year? Would you be interested in using something like this?

The post Alphacool’s new water cooling fittings double as a laser pointer first appeared on KitGuru.]]>
https://www.kitguru.net/components/matthew-wilson/alphacools-new-water-cooling-fittings-double-as-a-laser-pointer/feed/ 0